For projects in Maldives
Home theatre soundproofing and acoustics in Maldives
Serious equipment in a room with no isolation plan. The complaint is almost never the speakers. It is bass leaving the room and an untreated box making the system sound worse than it is. Concrete and block construction with hard floors, on islands where buildings sit close together and plant is never far from a bedroom.
- Containment
- Bass through the wall, floor and door. Mass and decoupling, with the door usually the weakest point.
- Low frequency inside
- Corner absorption with depth, before any surface treatment.
- Reflections
- Side wall and ceiling first reflection points at the seating position.
- Quote
- From a plan and a section, within 48 hours
01 / What it is
The material, and what it actually does on a Maldives job
Serious equipment in a room with no isolation plan. The complaint is almost never the speakers. It is bass leaving the room and an untreated box making the system sound worse than it is.
Concrete and block construction with hard floors, on islands where buildings sit close together and plant is never far from a bedroom.
Work reaching us from Maldives is mostly resort villas and guest rooms, spas, restaurants and bars, staff accommodation, back of house.
- Villas are lightly built Timber and light structures over water with little mass. Isolation between villas is limited by the construction, and we say so rather than overselling.
- The last leg is by sea Landing craft transfer means handling, spray and limited lifting. We wrap, brace and size pallets for that rather than for a truck dock.
- Salt air is relentless PET felt does not absorb moisture, rot or corrode. On an atoll that is not a preference, it is the only sensible choice.
- Containment Bass through the wall, floor and door. Mass and decoupling, with the door usually the weakest point.
Full specification
Thickness, density, NRC by frequency, fire class, standard sizes and build-up detail for home theatre soundproofing are on the main product page. This page covers what that means for a project in Maldives.
02 / The build-up
The stack, in the order it is installed
-
Layer 1
SoundBlanket mass loaded vinyl
A limp, high density sheet that adds mass to a partition, floor or duct without adding depth. In Maldives, split units, resort central plant and generator sets, all close to guest rooms on a small footprint.
Duct and plant wrap. Membrane wrapped over the duct with a decoupling layer beneath, sealed at every lap.
-
Layer 2
Soundproofing materials
The blocking side of the range taken together: mass loaded vinyl, resilient layers, cavity absorption and the build-ups they belong in. In Maldives, mosques, resort function rooms and conference spaces are hard volumes carrying amplified speech.
Floating floor. Resilient layer and deck, to break impact energy before it reaches the structure.
-
Layer 3
Soundproof curtains
A layered curtain with a mass loaded vinyl core, used where an opening has to stay an opening. In Maldives, school buildings are hard and naturally ventilated with open corridors and small hard halls.
Double layer at a doorway. Two curtains with an air gap where a single layer will not reach the target.
Architects working in Maldives usually need the build-up before the product. We will draw the section and mark what does the work. See how we support architects.
03 / Local conditions
What the buildings in Maldives do to the specification
- Villas are lightly built
Timber and light structures over water with little mass. Isolation between villas is limited by the construction, and we say so rather than overselling.
- The last leg is by sea
Landing craft transfer means handling, spray and limited lifting. We wrap, brace and size pallets for that rather than for a truck dock.
- Salt air is relentless
PET felt does not absorb moisture, rot or corrode. On an atoll that is not a preference, it is the only sensible choice.
- A short sea leg from India
Western India to Malé is quick, which makes modest and staged consignments practical for a resort refurbishment.
- The housing stock
Concrete and block construction with hard floors, on islands where buildings sit close together and plant is never far from a bedroom.
04 / Room by room
Space by space, for Maldives briefs
-
Containment
Bass through the wall, floor and door. Mass and decoupling, with the door usually the weakest point. Timber and light structures over water with little mass. Isolation between villas is limited by the construction, and we say so rather than overselling.
- Soundproofing materials, 2100 kg per cubic metre. 2.5 mm STC 30 at 5.25 kg per sq m, 4 mm STC 34 at 8.4, 6 mm at 12.6
- Soundproof curtains, 10 to 12 mm
- Acoustic carpet and rugs, High density polyester
-
Low frequency inside
Corner absorption with depth, before any surface treatment. Landing craft transfer means handling, spray and limited lifting. We wrap, brace and size pallets for that rather than for a truck dock.
- Soundproofing materials, 1800 x 900 x 20 mm, 100 kg per cubic metre, NRC 0.85
- Soundproof curtains, 5.5 kg per sq m
- Acoustic carpet and rugs, Felt
-
Reflections
Side wall and ceiling first reflection points at the seating position. PET felt does not absorb moisture, rot or corrode. On an atoll that is not a preference, it is the only sensible choice.
- Soundproofing materials, Mass, then decoupling, then cavity absorption, then sealing
- Soundproof curtains, Up to 30 dB
- Acoustic carpet and rugs, 64 sq ft per pack
Designers get colour, pattern and CNC options with the absorption figure attached to each. See how we work with interior designers.
04 / Conditions
The Maldives climate decides the material list
Maldives is warm and humid through most of the year, with a long wet season, and that narrows the material list before acoustics is discussed.
Humidity is the deciding factor. PET felt does not absorb moisture, shed fibre or feed mould, which is why it outlasts fabric-wrapped mineral wool in this climate. Wood wool and timber need a ventilated cavity behind them.
The failure we design against here is mould, sagging fabric finishes and swelling in timber.
Where a consultant is already engaged on a Maldives project, we supply to their specification and send the test reports rather than describing them. More on working with acoustic consultants.
06 / Before you buy
Where this kind of project usually fails
-
Foam on the walls as a soundproofing measure
This is the one that comes back as a second fit-out rather than a snag.
-
A standard door on a room built to hold bass
Soundproofing fails at the gaps, not the materials. One unsealed service penetration can undo a correctly built wall.
-
Treating before the room is sealed
Soundproofing fails at the gaps, not the materials. One unsealed service penetration can undo a correctly built wall.
-
Treating it as a generic Maldives job
Timber and light structures over water with little mass. Isolation between villas is limited by the construction, and we say so rather than overselling.
05 / Getting it there
Supply into Maldives, start to site
| Ships from | Palwal, Haryana, India |
|---|---|
| Arrives at | Malé, then boat transfer to the island |
| Dispatch | 4 to 7 working days |
| Freight | Sea via Malé, then boat |
| Support | Drawings, build-ups, BOQ and material that arrives complete |
Standard items dispatch in 4 to 7 working days. Grooved panels and custom colours take longer, and we say so before you order, not after.
Sea freight into Malé, then boat transfer to the island. Air freight for samples and small urgent items.
Questions from Maldives projects
What makes home theatre soundproofing and acoustics different in Maldives?
Concrete and block construction with hard floors, on islands where buildings sit close together and plant is never far from a bedroom. Landing craft transfer means handling, spray and limited lifting. We wrap, brace and size pallets for that rather than for a truck dock.
Where should the budget go first on a Maldives project?
Containment. Bass through the wall, floor and door. Mass and decoupling, with the door usually the weakest point. Low frequency inside. Corner absorption with depth, before any surface treatment.
Do you have an office or installation team in Maldives?
No. We manufacture in India and supply into Maldives. We give you drawings, build-ups, a BOQ and material that arrives complete, and we will tell you plainly when a job needs a local contractor we cannot be.
How does material get to a Maldives site?
ships from: Palwal, Haryana, India, arrives at: Malé, then boat transfer to the island, dispatch: 4 to 7 working days. Standard items dispatch in 4 to 7 working days. Grooved panels and custom colours take longer, and we say so before you order, not after.
What goes wrong most often on this kind of project?
Foam on the walls as a soundproofing measure. A standard door on a room built to hold bass.
What do you need from us to quote?
A plan, a section through the critical partition or ceiling, and what the room is for. From that we can give a build-up and a BOQ rather than a price per square foot.
Next step
Tell us the room, we will tell you the build-up
Send what you have. We will give you a layer by layer build-up, a bill of quantities and a date material lands, and we will flag anything in the brief that will not achieve what you want.